Widely used for water flow measurement; High Accuracy 0.5%; Output:4-20mA output; RS485 Modbus; GPRS wireless data transfer.Send Inquiry
Sea Water Flow Meter WFD Electromagnetic Flow Meter 4-20mA
The measuring principle of electromagnetic flowmeter is based on the electromagnetic induction law of Farady. The sensor is mainly composed of measuring tube with isolate lining, a pair of electrodes installed by penetration of the measuring tube wall, a pair of coils and iron core to produce working magnetic field. When the conductive fluid flows through the measuring tube of the sensor, the voltage signal in direct proportion to the average flow velocity of the fluid will be inducted on the electrodes. The signal is amplified and treated by the transmitter to realize various display functions
WFD Electromagnetic flowmeter can be used to measure the volume flow of conductive fluid in a closed pipeline. It is widely applied in the flow measurement and control in the fields of chemical and petroleum industry, metallurgy industry, water and waste water, agriculture and irrigation, paper making, food and beverage industry and pharmaceutical industry.
Ambient temperature: sensor: -25℃ to + 60℃; converter: -25℃ to + 60℃.
Relative humidity: 5% to 90%;
Maximum fluid temperature:
Polychloroprene rubber 80 ℃
Polytetrafluoroethylene at 100 ℃
Silicone rubber at 150 ℃
Polyurethane rubber at 70 ℃
Fluid conductivity: ≥ 5mS/cm
|Converter||Compact||Remote||Compact with Battery Power|
|Accuracy||0.5% of Rate||0.5% of Rate||1.0% of Rate|
|Min. Velocity||0.3 m/s||0.3 m/s||0.3 m/s|
|Max. Velocity||10 m/s||10 m/s||10 m/s|
|Turndown Ration||Standard 1:20; Others on request|
|Output||4-20mA/Pulse||4-20mA/Pulse||Consult the factory|
|Power Supply||(1) 110-240Vac||(1) 110-240Vac||Lithium Battery|
|(2) 18-36 Vdc||(2) 18-36 Vdc|
|Communication||Optional: RS485; MODBUS; HART; Profibus-DP|
|Protection Level||IP65||Converter: IP65||IP65|
|Sensor: IP65; (IP68 on request)|
|Installation||1. Flange (Standard: ISO; Optional: ANSI, DIN, JIS);|
|2. Thread (Standard: G; Optional: NPT);|
|Pressure Rating||Standard: 1.6Mpa; Others on request|
|Fluid Temperature||Standard: PTFE: <120°C (customized PTF)E: <120°C) ;|
l Measurement is not affected by the variation of flow density, viscosity, temperature, pressure and conductivity. High accuracy measurement is guaranteed according to the linear measurement principle.
l No obstacle in the pipe, no pressure-loss and lower requirement for straight pipeline.
l DN 6 to DN2000 covers a wide range of pipe size. A variety of liners and electrodes are available to satisfy different flow characteristic.
l Programmable low frequency square wave field excitation, improving measurement stability and reducing power consumption.
l Implementing 16 bits MCU, providing high integration and accuracy; Full-digital processing, high noise resistance and reliable measurement; Flow measurement range up to 1500:1.
l High definition LCD display with backlight.
l RS485 or RS232 interface supports digital communication.
l Intelligent empty pipe detection and electrodes resistance measurement diagnosing empty pipe and electrodes contamination accurately.
l SMD component and surface mount technology (SMT) are implemented to improve the reliability.
For example:100 represents DN100
Grade of protection
Power supply source
4-20mA, RS485 modbus protocol